Door will not run
Garage door repair in Oak Forest, IL
If your door jams, drops, shudders or sits lopsided, one component has usually given up. We trace the culprit, show you what we see, then mend it: springs, cables, rollers, track, photo-eye sensors or the opener.
- Springs, cables and rollers
- Doors back in the track
- Sensors and openers
Reasons to phone
How a worn-out part shows itself
Think of a sectional door as a set of parts sharing one load. Springs take the weight, cables and drums pass it along, rollers steer the panels up the track and two photo-eye sensors watch the doorway. Lose one piece and the rest strain, which is why trouble tends to announce itself in familiar ways.
If any of the signs below sound like your garage, have someone look at it. A door left open or jammed halfway also leaves the house exposed, so waiting rarely helps.
What goes into a repair visit
The symptom decides the job. Here are the repairs that come up most on home and commercial doors.
- New torsion or extension springs
- Cables, drums and rollers mended or swapped
- A door that jumped the track put back in line
- Dented or twisted track straightened or replaced
- Photo-eye sensors realigned or replaced
- Opener diagnosis and adjustment
Repair or start over?
Most breakdowns come down to a single component, and swapping that one component is the sensible fix. An aging door with several tired parts or crushed panels may be better replaced. We give you our honest opinion and our reasoning, and you make the call.
Home doors and commercial doors
Doors on commercial buildings cycle more, run bigger and heavier, and rely on operators made for constant use, so one symptom can trace back to a different cause. We service residential sectional doors, commercial doors and their operators.
When you phone, say what kind of door it is, roughly how large, and what it is doing, so the visit can be planned around it.
What you get from a visit
Diagnosis before parts
Springs, cables, rollers, track and sensors all get a look first, so you hear which one is at fault.
Level, easy movement
A door that is set right moves smoothly when lifted by hand and holds its position, the way an opener expects.
Sensors tested
Photo-eyes and the reverse function are checked on every repair, since a closing door has to stop for anything beneath it.
House or business
Sectional doors on homes and on commercial buildings, along with the openers that drive them.
Garage door repair questions
What stops a garage door from opening?
Common culprits are a broken spring, a cable that has let go, a door sitting out of its track, or a fault in the opener or sensors. Pulling the release handle and lifting by hand helps narrow it down, and we take it from there.
Should I try replacing a snapped spring on my own?
No. A wound torsion spring holds a lot of stored energy, and one slip with the wrong bar can badly hurt someone. Keep the door shut, leave the opener alone, and phone us to handle the spring.
Do you fix commercial overhead doors too?
Yes, we work on both residential sectional doors and commercial doors, plus their openers. Tell us about the door and its symptoms on the phone and we will plan the visit with you.
The motor runs but nothing moves. Why?
Frequently the opener is working and the trolley has come loose from the door, or a spring or cable has failed and the door is simply too heavy to lift. We look at the door, springs and opener together to see where the link is broken.
More of what we do
Jammed, noisy or lopsided door? Book a repair visit
Need a garage door repaired, installed, replaced or serviced? Say which, leave your number, and we will call to arrange a visit.